PeptideStack
5.2kquestions
20kanswers
220users

Is 20 mg/mL a sensible working concentration for dulaglutide, or should I go lower?

Asked 29 Nov 2025Modified 6 months agoViewed 3.7k times
3

What I have: 20 mg/mL · dulaglutide.

I want to know what the trade-off actually is rather than which option is fashionable.

I would rather have a defensible reason than a marginal improvement.

What does each option buy me, and what does it cost me?

diluent-volume
diluent-volume

Choosing how much diluent to add, which is really a question about what you want your measurement resolution to be. Larger volumes buy you…

308 questions
reconstitution
reconstitution

Taking a lyophilised vial to a solution of known concentration: choice of diluent, volume selection, how to add liquid without shearing the cake,…

330 questions
dosing-math
dosing-math

The arithmetic itself: milligrams to millilitres to insulin units, concentration after reconstitution, dose per draw, and vial-days per vial. Show…

811 questions
shareeditfollowflag
LF
askedleah_ferrers15k2729 Nov 2025

1 Answer

Accepted answer first, then by votes
39

Accepted answer

The underlying point is that two people working through the same arithmetic independently should get the same answer, and if they do not, someone has made a unit error.

Worked example, because the general form is easier to trust once you have seen it once. Take a 10 mg vial and add 2 mL of diluent: the concentration is 10 ÷ 2 = 5 mg/mL. A 0.5 mg dose is 0.5 ÷ 5 = 0.1 mL. On a U-100 syringe, where 1 unit = 0.01 mL, that is 0.1 ÷ 0.01 = 10 units. Change the diluent to 1 mL and the same dose becomes 5 units — same dose, half the resolution.

Reading a lyophilised cake

AppearanceInterpretationAction
Intact opaque puck, proud of baseCycle ran correctlyProceed
Slumped to one sideShipped before fully dry, or vibrationUsually usable; note it
Glassy translucent filmCollapse above glass transitionTest before use
Melt-back ring at stopperThermal excursion in transitTest before use
No visible cake at allVery low fill, or nothing thereWeigh it; query the supplier

Air bubbles at these volumes are a measurement problem rather than a safety one. A 2 mm bubble in a 0.3 mL syringe is roughly 4 µL, which at 10 units drawn is a four per cent error.

The insulin-unit standard U-100 means 100 units per millilitre, so one unit is 0.01 mL — this is the conversion that trips up more people here than any other single piece of arithmetic.

If in doubt, use more diluent and accept the shorter usable window.

edited 24 Jan 2026 by claudia_ferrante — removed a claim I could not source

shareimprove this answerflag
CF
answered · acceptedclaudia_ferrante46k388 Jan 2026
4Any reason this would differ for a longer peptide? – Dr_Fatima_Belkacem 7 months ago
add a comment
Sponsored

Sigma-Aldrich - Certified Reference Materials

Analytical standards and reagents with traceable certificates. Every quantitative result you read inherits the accuracy of the standard behind it.

Shop standards

Your answer

Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.

Not medical advice. Research-use-only compounds are not approved for human use.