PeptideStack
5.2kquestions
20kanswers
220users

What happens to liraglutide after three weeks at 25 °C in solution?

Asked 31 Jan 2025Modified 14 months agoViewed 32k times
20

The particulars: liraglutide · three weeks · 25 °C.

I understand the observation; what I do not understand is the mechanism behind it.

I have read the two review articles that come up first and both assert this without a citation to a primary source.

Can someone derive this rather than assert it?

peptide-stability
peptide-stability

The chemistry of peptide degradation: deamidation, oxidation, hydrolysis, aggregation and fibrillation, and how temperature, pH, ionic strength,…

908 questions
storage
storage

Storage conditions and their evidence base: minus twenty degrees for powder, refrigerated for solution, protection from light, and what the…

701 questions
shelf-life
shelf-life

How long a preparation remains within specification: labelled expiry for a sealed lyophilised vial, beyond-use dating after reconstitution, and…

327 questions
liraglutide
liraglutide

A once-daily GLP-1 receptor agonist and the compound that established the class. Still relevant for its shorter half-life, its paediatric and…

235 questions
shareeditfollowflag
CH
askedcal_hennessy17k2731 Jan 2025

5 Answers

Accepted answer first, then by votes
18

Accepted answer

three weeks is 21 days, which at 25 °C is on the order of 84 refrigerated days. 25 °C is 20 kelvin above the 5 °C middle of a 2–8 °C refrigerator. The ten-degree rule of thumb — degradation rate roughly doubling per 10 K — makes that about 4 times the refrigerated rate, which is an order-of-magnitude statement and not a shelf life. In solution the routes that matter are hydrolysis of the backbone, deamidation at Asn, and physical association — the first two cost content, the third costs neither until it precipitates. Over 21 days at 25 °C you should expect all three to have moved, and a purity figure to have noticed only some of them. Reconstituted material has no certificate; the one in the box describes the powder.

Asparagine and glutamine are the deamidation risk, and methionine is the oxidation risk.

Hydrolysis cleaves the backbone, most readily at aspartate-proline and aspartate-glycine sequences, and is acid-catalysed. In a dry solid it barely proceeds at all.

Freeze-thaw cycling drives aggregation through concentration at the ice interface and pH shifts as buffer components crystallise out at different rates. Each cycle costs something.

Deamidation via the succinimide intermediate is well characterised, with sequence-dependent rates highest for asparagine-glycine motifs.

Sequence determines which pathways apply, so general statements are general.

Cold, dry, dark, still. Those four words cover most of the mitigation.

shareimprove this answerflag
TH
answered · acceptedtyndall_haze38k3822 May 2025
Sponsored

PeptideMeter - Independent Peptide Analytics

Aggregated, published test results and vendor ratings built from submitted batches. Methodology stated, dataset browsable, no listing fees.

Browse results
21

The relevant point is that a mass shift of plus one dalton is deamidation and plus sixteen is oxidation, so degradation is often visible in a mass spectrum if anyone looks.

Deamidation converts asparagine or glutamine to the corresponding acid via a succinimide intermediate, adding one dalton. It is base-catalysed, accelerates above neutral pH and is the dominant aqueous pathway for many peptides.

Light exposure matters for tryptophan-containing sequences and for anything with a chromophore. Amber vials and a closed box are free mitigations.

Aggregation at air-liquid interfaces is established from surface-tension and particle-count studies and is the basis for anti-agitation handling guidance.

Nothing here is medical advice, and research-use compounds are not approved for human use.

A mass spectrum names the pathway. Plus one, plus sixteen, minus eighteen.

edited 9 Mar 2025 by ekaterina_volk — reworded for clarity after a comment

shareimprove this answerflag
EV
answeredekaterina_volk21k2813 Feb 2025
Two lots stored differently, reassayed at a year — the difference was smaller than I expected. – ilaria_bertone 8 months ago
add a comment
15

The short version: water enables most of it, oxygen enables oxidation, surfaces enable adsorption, and agitation enables aggregation.

A mass spectrum resolves most of this: minus eighteen is dehydration or succinimide, plus one is deamidation, plus sixteen is oxidation, and an unchanged mass with a shifted retention time is an isomer.

Stated carefully, oxidation targets methionine, cysteine and tryptophan, adding sixteen daltons per oxygen. It is catalysed by trace metals and promoted by dissolved oxygen and by light.

Adsorption losses at low concentrations are quantified in formulation studies and are the reason carrier proteins are used in dilute preparations.

The caveat is that none of these pathways can be seen by looking at a vial, and a clear solution can be substantially degraded.

Sequence decides which pathways are even available. Check the residues.

shareimprove this answerflag
LC
answeredlyoph_cake78k2672 Feb 2025
7Does the same reasoning apply to material already in solution, or is that a different curve? – unit_math 7 months ago
8I would add a sentence about light, since tryptophan-containing sequences care. – micron22 9 months ago
add a comment
9

The honest answer is that most reported "degradation" is adsorption and dilution error rather than chemistry.

Adsorption onto glass and plastic is significant at low concentrations — micrograms per millilitre — and negligible at milligrams per millilitre. It is the usual explanation for an apparent loss in a dilute preparation.

Metal-catalysed oxidation of methionine is documented across peptide and protein formulations and is why chelators appear in some formulations.

Swirl, never shake. Aggregation is a handling problem more than a time problem.

shareimprove this answerflag
HN
answeredhalvard_ness69k4730 Apr 2025
8

Answering this needs the physical state, since a dry powder is protected from most of these and a solution is protected from none.

Aggregation is physical: peptides unfold at air-liquid interfaces and associate. Shaking maximises that interface, which is why swirling and shaking produce visibly different outcomes on the same vial.

Apparent loss in a dilute preparation is usually adsorption rather than degradation and is worth ruling out first.

At dilute concentrations, suspect adsorption before you suspect chemistry.

shareimprove this answerflag
M4
answeredmz_4113101k35811 May 2025

Your answer

Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.

Not medical advice. Research-use-only compounds are not approved for human use.