What is the arithmetic to convert 5 mg in 1.5 mL into units on a U-100 scale?

Setup, so nobody has to ask: 5 mg · 1.5 mL.

I have worked this out and I would like someone to find the error, because I suspect there is one.

My working so far, for the record, is below, and I am fairly sure the error is in the unit conversion rather than the algebra.

How many significant figures are actually justified here?

The answer depends on exactly which dose and which vial you are asking about, but the method is always the same.

Room temperature before drawing is worth the ten minutes. Cold solution is more viscous, draws slower, and condensation on a cold barrel makes it harder to read the meniscus.

Number of stopper piercings matters less than the gauge doing the piercing. A 30G or 31G needle through a butyl stopper leaves a track that reseals; a 21G or 18G drawing needle punches a core and can drop it into the solution.

The content assay results from major testing services show that nominal vial claim and measured content differ by one to ten per cent, making content a driver of dose error.

The caveat is that this assumes the vial contains what the label says, and if the content assay has not been done, the arithmetic is precise about an unknown quantity.

If in doubt, use more diluent and accept the shorter usable window.

This is arithmetic, so let us do the arithmetic rather than argue about it.

The rounding error accumulates if you round too many times — rounding concentration to 5.0, rounding the dose volume to 0.1 mL, rounding the unit reading to 10 — and the safest approach is to work the full precision and round only the final answer.

Concretely, rotation of injection site is a tolerability measure, not a pharmacokinetic one, but if you are going to do it you might as well do it right.

The Arrhenius relationship for drawing kinetics means that cold solution takes noticeably longer to draw than room-temperature solution.

Write the arithmetic on the vial label. It costs nothing and removes the step where you reconstruct it from memory.

edited 15 May 2025 by u100_marks — added the placebo-arm figures

Specifically, the arithmetic only stops being confusing once you work it through once and see that it is straightforward.

Worked example, because the general form is easier to trust once you have seen it once. Take a 10 mg vial and add 2 mL of diluent: the concentration is 10 ÷ 2 = 5 mg/mL. A 0.5 mg dose is 0.5 ÷ 5 = 0.1 mL. On a U-100 syringe, where 1 unit = 0.01 mL, that is 0.1 ÷ 0.01 = 10 units. Change the diluent to 1 mL and the same dose becomes 5 units — same dose, half the resolution.

The insulin-unit standard U-100 means 100 units per millilitre, so one unit is 0.01 mL — this is the conversion that trips up more people here than any other single piece of arithmetic.

Write the arithmetic on the vial label. It costs nothing and it removes the step where you reconstruct it from memory at an inconvenient moment.

edited 31 May 2025 by t_oyelaran — updated for the 2026 guidance change

In practice, this is one of those calculations where checking your work takes two minutes and prevents a very consequential error.

On filtration: a 0.22 µm syringe filter will remove particulates and organisms, and it will also adsorb a fraction of your peptide onto the membrane — with a low-binding PVDF or PES membrane the loss is typically a few per cent.

The practical summary: fine gauge, gentle swirl, diluent down the wall, room temperature before drawing, and check the syringe scale against the barrel rather than against your assumption.