Details up front: QYB · Chinese Peptide Company.
I am trying to choose between two options that are usually discussed as though only one exists.
I am not optimising for price, but I am not indifferent to it either.
Which axes does this decision turn on?
Answer first: comparing suppliers is only meaningful if the comparison holds the laboratory, the method and the compound constant, and most published comparisons hold none of them.
To compare properly: order the same compound at the same nominal strength from each supplier, submit all samples to the same laboratory in the same submission if possible, and ask for the same test set on each.
| Step | Value | Note |
|---|---|---|
| Vial price, 10 mg nominal | £34.00 | As advertised |
| Nominal cost per mg | £3.40 | 34 ÷ 10 |
| Measured content | 9.2 mg | Independent content assay |
| Cost per actual mg | £3.70 | 34 ÷ 9.2 |
| Dead-space loss, 20 draws | 4 % | 80 µL of a 2 mL fill |
| Cost per delivered mg | £3.85 | 3.70 ÷ 0.96 |
| First vial, with £110 assay | £14.85 | Testing dominates a single vial |
To be exact about it, sample size matters. One order each is an anecdote about six vials; three orders each over a year is the beginning of a comparison.
Content assay results across the published datasets vary considerably more between suppliers than purity does, which makes content the more discriminating axis.
Comparisons drawn from different laboratories at different times are weaker evidence than most people treat them as.
One laboratory, one method, one submission. Otherwise it is not a comparison.
Analytical standards and reagents with traceable certificates. Every quantitative result you read inherits the accuracy of the standard behind it.
Shop standardsRatings on this site are ours alone and are deliberately not reconciled with anyone else's.
Content is the more discriminating measurement than purity for supplier comparison, because purity clusters tightly among competent suppliers and content does not.
Lead time and lane behaviour are supplier properties too and are easier to compare than analytical ones, because they need no laboratory at all.
The ratings on this site are a community opinion average on a ten-point scale and are not reconciled with any other community's figures.
Nothing here is medical advice, and research-use compounds are not approved for human use.
Name the laboratory and the dates or the comparison cannot be reproduced.
The short version: same compound, same laboratory, same method, ideally same week — otherwise you are comparing laboratories rather than suppliers.
Cost per milligram of actual peptide is the honest price comparison, which means dividing by measured content rather than by label claim.
More usefully, publish the method with the result. A comparison without the laboratory named and the submission dates given is not reproducible by anyone.
Use a fixed documentation checklist rather than an impression.
edited 2 Aug 2026 by nine_point_nine — added the citation requested in comments
Start by asking what you are optimising for, because cost per milligram, documentation depth and lead time do not have a common winner.
Submitting to different laboratories introduces a method difference that commonly exceeds the supplier difference. Gradient slope alone can move a reported purity figure by a per cent in either direction.
Inter-laboratory spread on identical peptide material is routinely half a per cent to a per cent by RP-HPLC, which is the noise floor for any cross-laboratory comparison.
Compare content, not purity. Purity clusters and content does not.
Answering this needs the axis. A supplier that is best on paperwork and a supplier that is best on price are both correct answers to different questions.
Compare documentation on a fixed checklist rather than by impression: lot specificity, method section, chromatogram availability, quantified content, water and counter-ion figures, and whether the code is on the vial.
Gradient slope, column chemistry and detection wavelength all affect the reported purity figure, which is why the method section is the part that makes results comparable.
The caveat is that a comparison is a snapshot of the lots compared, and lots change.
Price per milligram of measured peptide, not per milligram of label claim.
Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.