The case in front of me: 10 mg · oral semaglutide.
Please show the division. I want to check my own against yours.
I would like the general form as well as the specific number, so I can apply it again.
Is my approach right even if my number is wrong?
The relevant detail is that most research-grade certificates report purity without content, which is exactly backwards from what users actually need.
System suitability for a quantitative method is stricter than for purity because a small systematic error in the standard directly translates into an error in the sample result.
Peak area for a standard of known weight produces a response factor — area per unit mass — which is then applied to the sample peak to infer sample mass.
The relative standard deviation on replicate quantitations of a homogeneous sample should be below two per cent when the method is under control.
Ask for both the purity and the content, and do not accept purity alone.
Analytical standards and reagents with traceable certificates. Every quantitative result you read inherits the accuracy of the standard behind it.
Shop standardsConcretely, reading a content result requires knowing the purity of the standard against which the sample was quantified, because your result inherits that uncertainty.
If the standard and sample have different absorption coefficients at the detection wavelength, the response factors differ and the inference fails.
The relevant detail is that quantitation against a certified reference material assumes the sample and standard are treated identically through the analytical method, which is why the method for calibration matters as much as the method for measurement.
Worth noting that the standard certificate carries its own uncertainty, usually on the order of two to three per cent, which the sample result inherits.
The practical summary: if you are ordering from a new supplier, budget for content assay on the first lot.
Content assay and purity are orthogonal measurements answering orthogonal questions, and the confusion between them is one of the most expensive misreadings in this space.
The single most common reason for disagreement between a supplier content figure and an independent assay is using different standards.
Running multiple independent aliquots of the same sample should give results that agree to within the method precision, which is usually one to three per cent.
Pharmacopoeial guidance on quantitative methods specifies validation steps for linearity, range, accuracy and precision that most research-grade work does not claim to meet.
The limitation is that a quantitative method is only as good as the standard it uses, and a cheap standard is a false economy.
If a supplier gives you content without the standard's purity, ask them to provide it.
Content assay requires a reference standard of known purity and traceability, which is why it costs more than purity testing does.
If a sample shows high purity but low content, the explanation is usually that the standard used for quantitation had a different purity than claimed.
Quantitation against a standard requires that the standard be traceable to a national metrology institute, and certificates for research-grade standards claim that traceability.
Ask for both the purity and the content, and do not accept purity alone.
edited 5 Feb 2025 by e_dziedzic — added the method parameters
Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.