The particulars: 15 mg · semaglutide.
I would like the arithmetic checked rather than the conclusion asserted.
I have deliberately not used an online calculator because I want to be able to check the result.
What is the general form of this calculation?
The underlying point is that a high purity does not guarantee high content because it says nothing about how much of anything is in the vial — a vial could be 99 per cent pure but only half full.
Comparing content results from different laboratories requires knowing whether they both used certified reference materials or whether one used an in-house standard of unknown provenance.
On the detail: peak area for a standard of known weight produces a response factor — area per unit mass — which is then applied to the sample peak to infer sample mass.
Quantitation against a standard requires that the standard be traceable to a national metrology institute, and certificates for research-grade standards claim that traceability.
I would not rely on a content figure from a lab that is not willing to state their standard's purity on request.
The practical summary: if you are ordering from a new supplier, budget for content assay on the first lot.
Analytical standards and reagents with traceable certificates. Every quantitative result you read inherits the accuracy of the standard behind it.
Shop standardsStart from what you are trying to know — whether a vial contains what the label claims — and purity does not answer that question.
The single most common reason for disagreement between a supplier content figure and an independent assay is using different standards.
A content assay is always paired with a purity assay because purity tells you what fraction of the measured mass is the target and content tells you the total measured mass.
Pharmacopoeial guidance on quantitative methods specifies validation steps for linearity, range, accuracy and precision that most research-grade work does not claim to meet.
Ask for both the purity and the content, and do not accept purity alone.
edited 6 Nov 2024 by k_szabo — corrected a unit error in the worked example
The honest answer is that you cannot know for certain what you have without a content assay, and the purity number alone is not enough.
Water content and counter-ion content are part of the gross mass but not part of the content assay result, which is why the two do not sum to label claim.
On the detail: the purity of the reference standard is stated on its certificate, and your content figure is only as good as that purity certificate is.
Where content data have been published from testing services on common peptides, the spread between services on identical material is typically a few per cent.
If a supplier gives you content without the standard's purity, ask them to provide it.
The label claim is usually the gross mass of the lyophilised solid, which is not the same as the content, because the solid contains water, counter-ion and other non-peptide mass.
Quantitation against a certified reference material assumes the sample and standard are treated identically through the analytical method, which is why the method for calibration matters as much as the method for measurement.
The relative standard deviation on replicate quantitations of a homogeneous sample should be below two per cent when the method is under control.
Worth noting that the standard certificate carries its own uncertainty, usually on the order of two to three per cent, which the sample result inherits.
The practical summary: if you are ordering from a new supplier, budget for content assay on the first lot.
Put another way, content assay and purity are orthogonal measurements answering orthogonal questions, and the confusion between them is one of the most expensive misreadings in this space.
If the standard and sample have different absorption coefficients at the detection wavelength, the response factors differ and the inference fails.
One qualification: a single result from a single vial is a point estimate, and repeating the assay on a second aliquot is worth doing if the first result is surprising.
Ask for both the purity and the content, and do not accept purity alone.
Ask PeptideStack is a static archive. Posting is closed, but the norms are worth stating: answer the question that was asked, show your working, cite the trial or the certificate, and say plainly where the evidence runs out.